Application Examples – Mass Finishing
Before and after
To illustrate the wide range of possibilities offered by mass finishing, we have described and pictured a small selection of components and processes below.
Drag the slider in the image to compare the condition before and after processing.
3D-printed component
For processing this bottle opener, we chose our High Speed Centrifugal Machines.
The component was first ground and then polished.
- Processing
- grinding and polishing
Mirror finish
Polished with walnut shell granulate and various compounds.
A high-gloss finish requires several polishing runs in a High Speed Centrifugal Machine. Depending on the desired result and the surface condition before polishing, three to five cycles are necessary.
- Media
- walnut shell granulate and compounds
- Cycles
- three to five
Processing a titanium component
We processed the titanium component in two cycles of 60 minutes each.
In the first cycle, the component was ground and the milling marks were removed. Polishing followed in the second cycle. Processing took place in one of our High Speed Centrifugal Machines, using a combination of wet and dry processes.
- Material
- titanium
- Cycles
- 2 × 60 minutes
- Process
- wet and dry
Mass finishing of Inconel 718 for aerospace
This 3D-printed component for the aviation sector was processed in our rotary vibrator.
We were able to reduce the surface roughness considerably.
- Material
- Inconel 718
- Machine
- Rotary vibrator
- Media
- ceramic media
- Process
- wet
Acrylic component: satin finished
The acrylic parts were processed with our special nuggets for satin finishing surfaces.
Processing is possible with all common mass finishing machines. The process is dry.
- Material
- acrylic
- Media
- special nuggets
- Process
- dry
3D-printed component: titanium
Two cycles to the result in our High Speed Centrifugal Machines.
- 1st cycle grinding with ceramic media
- 2nd cycle polishing with ceramic balls
- Material
- titanium
Fitting from fine grinding to high gloss
Processed in our High Speed Centrifugal Machine.
- Wet process with plastic cones
- Dry process with walnut shell granulate and compound
Grinding and polishing plastic parts
Grinding and polishing in two wet runs.
The choice of media and machine technology depends on the properties of the components.
- Material
- plastic
- Runs
- two
- Process
- wet
Deburring rings
Depending on material thickness, alloy and component size, different media were used, varying in shape and composition.
- Processing
- deburring
Your component is not listed?
Send us your components for a mass finishing trial. We determine a suitable process and the right media and show you the result on your own parts.